A arm material

For asking and answering questions regard the NZ Hobby Car Tech Manual.

Rules:
Only ask and answer questions about the NZ Hobby Car Tech manual any other questions not releated please ask in the other tech forums.

Moderators: Simjen, KiwiBirkin

Post Reply
bzrse7en
Posts: 1467
Joined: Thu Apr 23, 2009 3:40 pm
Location: Rolleston Canterbury

A arm material

Post by bzrse7en » Sun Dec 11, 2011 9:33 am

Hi
Does the Hobby car manual have a table of approved materials for A arms based on vehicle weight / power etc, or is it still an arbitrary 25 x 2mm ERW?
I am interested in knowing what specs are allowed when using about 22 dia. tube - LVVTA have said I can use 22 x 2.5 wall Erw , but this doesn't exists as far as I can tell and 25 OD is too big.
Are there specs for 4130 etc?


Thanks
Patrick

McGregor Motorsport

Re: A arm material

Post by McGregor Motorsport » Sun Dec 11, 2011 11:49 am

I have some of the correct 22 in stock , come have a look.

bzrse7en
Posts: 1467
Joined: Thu Apr 23, 2009 3:40 pm
Location: Rolleston Canterbury

Re: A arm material

Post by bzrse7en » Sun Dec 11, 2011 5:29 pm

Will do, thanks

Post Reply